Recent content by ws62000

If the silver qc was on or near Grandpark Way it may have been me

True. I have a drb at work, i installed a used ecm in my truck. Its done in the skim module . It will ask for your vehicle pin then ask to enter the mileage on the odometer. and its done.

My qc was doing something similar to what you are describing. there are some body grounds on both fenders under the hood on the upper edges. take the bolts out and scrape the paint off the fenders and bolt them back up. that took care of all my problems. give it a shot dosent cost anything just...

Did you find the bracket you needed ?

Yes you can replace your ecu with another dosent matter who flashes it. it wont change the perameters. you can get your pin number from the dealer. it can be done .but who ever does it has to have a dealer scan tool.

It rocks. night and day difference .should have done it long ago.

You just need the vehicle pin number and once u enter that in it will show the vin and ask u if its correct .hit enter and its done.

Mine worked like a champ. you just have to know how to use the drb

Our trucks have skims . it flashes the vin thats in ur skim to the ecu.

with drb 3 you go into the skim module and select replace ecu enter your vehicle pin and thats it

It can be done . I just bought a ecu from Fahrenheit i just flashed the vin . I use same equipment as dealer does.

sounds like your wheel bearing. jack that side up and wiggle the tire to if the bearing feels loose.

daily driver here.i have other vehicles to drive ,but the 10 is the one i like drivin.

i the same problem with mine.it was the rear exhuast hanger on my magnaflow rubbing the bumper bracket

130 but it had more left in it. wont do it anymore, was a little scary