rreinicherr
Full Access Member
- Joined
- Sep 25, 2006
- Messages
- 308
- Reaction score
- 0
I just bought a extra set of heads to be ported. I am on a limited budget. Can I get a good port job with a Cam without putting in new rockers. My goal is low end torque and maybe just touch 500 RWHP.
I kind of planned on new pushrods, if needed, and of course new bigger valves.
I can't afford rockers because then I would have to get a spacer at the minimum. That is out of my budget right now.
I have been in touch with "Bone" and "msdnga" about some ideas and pricing.
Should I wait until I can get Rockers or go for it now?
All suggestions appreciated. I am in new territory with heads. I have already done many searches and reading about it.
THANKS! :rock:
I kind of planned on new pushrods, if needed, and of course new bigger valves.
I can't afford rockers because then I would have to get a spacer at the minimum. That is out of my budget right now.
I have been in touch with "Bone" and "msdnga" about some ideas and pricing.
Should I wait until I can get Rockers or go for it now?
All suggestions appreciated. I am in new territory with heads. I have already done many searches and reading about it.
THANKS! :rock: