SRT-MIKE
Full Access Member
What would make it difficult to shift while the truck is at a dead stop?
Sometimes it is hard to get it into 1st gear, and putting it into reverse even worse. I've had to shut the truck off to shift it into reverse, then crank it again in gear.
Shifting into second gear followed by a shift into first, works once in a while but not always.
Shifts good while rolling.
Any ideas?
Thanks
Sometimes it is hard to get it into 1st gear, and putting it into reverse even worse. I've had to shut the truck off to shift it into reverse, then crank it again in gear.
Shifting into second gear followed by a shift into first, works once in a while but not always.
Shifts good while rolling.
Any ideas?
Thanks