Geodriller
Full Access Member
I have a '96 dodge am 1500 QC long bed 4X4. the last week or two i have noticed the brakes are squeekin real bad, at around the same time, al of the sudden the truck would pull hard to the left when breakin. slightly yet noticable at low speeds and dangerusly at high speeds (interstate), it would damn near throw u in theother lane.
so i figure the passenger side caliper was not workin andthe frot end needed brakes. so i get the tires off but i dont see any leaking brak fluid, but where the caliper meets the pad u could see some rust like the caliper was not pushing the pad, mostly on the inside where the piston is. all pads and rotors acctually looked real good so i just replaced the caliper on the right side, left side looked perfect.
Well nothing changed, still pulls hard to the left. all fluid is toped of, and everything includin lines look good. I bled the caliper that i put on but nothing else. Am i missing something. any ideas why this would be happening???
so i figure the passenger side caliper was not workin andthe frot end needed brakes. so i get the tires off but i dont see any leaking brak fluid, but where the caliper meets the pad u could see some rust like the caliper was not pushing the pad, mostly on the inside where the piston is. all pads and rotors acctually looked real good so i just replaced the caliper on the right side, left side looked perfect.
Well nothing changed, still pulls hard to the left. all fluid is toped of, and everything includin lines look good. I bled the caliper that i put on but nothing else. Am i missing something. any ideas why this would be happening???
