Project SLAYtona

[JaysSRT10]

the factory rods will hold up to a lot of abuse. I know guys still running them with Holset's and pushing 30 pounds of boost with no issues.

 

[Wastelands Warrior]

the factory rods will hold up to a lot of abuse. I know guys still running them with Holset's and pushing 30 pounds of boost with no issues.

It's subjective...I know guys who have gone *BOOM* at around 20 lbs of boost w/ meth injection on stock rods. I think a lot of it is in the tune. But since my engine will need a freshening up at some point I will look to make improvements. And I do have a set of hard to come by 4 bolt main caps just collecting duct, so might as well use 'em. :rock:

 

[Wastelands Warrior]

I was just by my buddy's shop, and the trans is back in with the new clutch, pressure plate, throw out bearing, lightened flywheel, short shifter, and new cables all installed. I dropped off the tranny oil I want to use, so there is a good chance I might be able to drive it tomorrow before the next snow...:dontknow: