Search results

Which part was close? width or length? I need to haul a QC.

For trailering your RC, what was close? the width or the length? I need to transport my QC and dont know if itll fit.

Is this still the case? I need to replace the fan, its in slow mode only. I replaced the PS pump and lines. I am replacing the thermostat and water pump this week. ____________________________ "Hello: We have the same hydraulic-fan system that is used on the 2006 5.7L Hemis so there are a...

2006 QC NR Is this the same oil filter you guys are using? Mopar Oil Filter: 05037836AB https://www.factorychryslerparts.com/products/FILTER-Engine-Oil/4299933/05037836AB.html

Replacing this switch/sensor today. Where is it located? No gasket just thread lock? Hand tight or is there a torque spec?

Looking for a 2006 QC Driver Sun Visor w/light Grey would be wanted.... Visor, Left Part # 1CT21BD1AA

I about trashed my truck the other day thinking that the truck wouldnt unlock from the key. Found out that its only the Driver Rear door that is not doing anything. All other doors work properly. No Power seems to be going to it for lock/unlock or windows. Is there a fuse just for the back...

For those who have painted or had it their trucks painted, where did you go and what did you take? Just your paint code and they did the rest? I am getting into repainting my hood and other than my code PRX, I dont have much else. Reputable reps that dont only take Gold bars as payment?

The 2006 QC NR is coming up to its 100,000 miles mark and I am looking to do a major service to it. I've owned it since 2011 as the 6th owner Nothing has been done to it besides regular oil changes and replace things that break: -Oil changes ~6k miles -Power Steering Pump -Radiator -Valve Cover...

This may vary from State-to-State but I haven't found anything on it legally saying we can do it. Texas says: "No Texas law forbids adults from riding in the back of a pickup truck. While it’s not uncommon to see farmers and ranchers in rural areas of Texas moving their workers from place to...

Well good news. the blinking stopped. Bad news... the whole thing stopped. no lights, blinking or heat.....

06 QC NR power seats work just fine, but the seat slides about an inch back/forth under gas/brake. Doesn't seem to be a deadly issue, but quite annoying. Bad motor, brackets, pin...ect?

I haven't needed them since its a million degrees out these days but the heated seat buttons are blinking at me and are not functional in any way. Anyone experience the same thing? solution?

:D:D:D:D:D:D

i am rebuilding my fronts right now and I have only been able to get 1 of 8 pistons out so far... im going to nap and then get back on it with some new kind of love.

quad cabs dont have these problems

dumb question, but would it be compatible with the stock media unit of the trucks?

is it detrimental or can it wait to replace? is that a universal pedal throughout ram 1500s or SRT10 specific?

When I drive the truck and press the Brake pedal down it swings from side-to-side. It does not do it when it is at the top, only when pressed. When I look below, i didn't see any mechanical damage to the pedal assembly, but the more i can learn the better. Ideas, theory's, solutions...

I am needing parts or a lead to parts. 2006 QC Driver side Front Upper/Lower Control arms (Stock).