710 Cam

[NVR2OLD]

I haven't tore down my motor yet, but I'm thinking about putting in the 710 cam. I would like to know if you lose any low end torque with the 710 cam? If I can afford it maybe forged pistons and rods.

I still don't know if I got a rod or piston, but hopefully my mechanic will start tear down Thursday.

 

[oldcolt]

PM ronnie. He can give you some helpful info on cams.

 

[FATJACK]

Our rods are decent..you really should replace the pistons.

 

[NVR2OLD]

Our rods are decent..you really should replace the pistons.

I will at least put in pistons along with valve springs and pushrods with cam.

 

[stealth78]

How good are our stock rods? How much HP or boost (if FI) can our rods take?

 

[Ironhead]

. I would like to know if you lose any low end torque with the 710 cam? If I can afford it maybe forged pistons and rods..

I will let you know how it works with a set of strikers and forged bottom end with 10.8 to 1 compression in about a month baby :rock:

 

[stealth78]

I will let you know how it works with a set of strikers and forged bottom end with 10.8 to 1 compression in about a month baby :rock:

Hey Ironhead, I was hoping to get a reply from you on my heads and valvetrain post but apparently you never went back to it. How was the driveability on the Crower stage 2 cam?

 

[Ironhead]

Hey Ironhead, I was hoping to get a reply from you on my heads and valvetrain post but apparently you never went back to it. How was the driveability on the Crower stage 2 cam?

Runs like a raped ape ,but I'm swapping out the crower soon to go with a higher lift to get all i can out of the strikers
I would recommend it with no problems to a stock upgrade setup and the price is right also

 

[stealth78]

Thanks bud

 

[Yellow venom]

Hey Ironhead, with that 710cam did you lose any bottom end or do the Strikers make up for it if there was? Just curious on how the cam performs.

 

[Ironhead]

Hey Ironhead, with that 710cam did you lose any bottom end or do the Strikers make up for it if there was? Just curious on how the cam performs.

dont know i have not put it in yet :dontknow:

 

[Yellow venom]

dont know i have not put it in yet :dontknow:

Ok, lol. Sorry, I Thaught you had in already,my mistake! Lol