Anyone had to rebuild theirs yet? Mine is starting to only want to spin one tire intermittently now. Any links to a rebuild kit?
have ya tried fresh juice with a double dose of friction adder??
its got royal purple with the friction modifier, the cover has never been off the diffUse synthetic fluid, then you don't need friction modifier. Are your spider gears cryoed?
new clutch pack 200 buckaroos ,tool to remove packs 65 on ebay ,,
no extra room ,plus it is a tight mother to get them in as it is,when i installed my cryo spiders i went ahead and changed the packs just because i was already there
I may end up just replacing the packs, I've had cryo spiders for several years now and just never put them in.
you have to remove the spyder gears to get packs out ,,might as welll put them in
I thought for a second you were talking about just doing packs and not gears ,my badYup, just haven't put them in because I haven't had any issues until now
I thought for a second you were talking about just doing packs and not gears ,my bad
Kinda surprised my spiders haven't come apart yet, I've been pretty hard on the truck, is the axle spreader a must have or just something to make it easier to get the carrier out? I've never messed with a dana 60
I just dropped my truck off to get 4.88's put in. The installer called me a little later and said he pulled the cover off and the pin was broke off one side and some of the clutches were laying in the bottom of the rear. Funny thing is, I know the posi was working with no issues when I took it in. Is this a common failure?
Kinda surprised my spiders haven't come apart yet, I've been pretty hard on the truck, is the axle spreader a must have or just something to make it easier to get the carrier out? I've never messed with a dana 60
I have the spreader and clutch pack tool Justin if you want to bum them .just have to pay shipping to and fro .they are a bit heavy though
Yeah, cryo treated factory spider gears