mopower1958
Full Access Member
- Joined
- May 20, 2006
- Messages
- 2,482
- Reaction score
- 0
I just finished an '05 4wd Hemi truck that had a bent rod. He had a cold air kit with a cone filter on it, went through some deep water on the street,it ingested water and it bent #1 rod and of course the crank broke the piston. I was able to just put a rod and piston assembly from Chrysler in it but beware of where the filter is located if you have a cold air kit..his was down almost to where the inner splash shield stops just above the frame. He is going to move it up higher on the inner splash shield.
