Chris@K54L
New Member
Where do I go to look at pricing for the exhaust, or even just muflfers? I can't pm, yet, so I apologize. Thanks!!
- Christopher
- Christopher
So do you have a site where I can look at the products you offer?
Sorry for the thread jack but I didnt want to make another thread and I haven't received a response from my pm I sent you a while ago.
@venomous1 racing
Thank you
I am looking at the rear exit snakebite exhaust. Do you make a flange on the ends where it can directly bolt to the stock manifolds of aftermarket headers?
what benefits do we get when we switch to a full 3 inch exhaust
Gotcha. Call ya in a bit on that. ThanksNo flanges as the piping is run by your local exhaust shop boss. Works with headers or manifolds.
Thanks
Our Side or Rear exit SnakeBite exhaust kit is $340 shipped. $850 installed locally. Consists of muffler, X-Pipe, and side exit plates. Piping is run by us or your local exhaust shop in 3" aluminized.
Thanks for your interest,
Scott
How do you run the exhaust to the drivers side? Do you cut a hole in the frame or run it under the frame?
This is the only way to do it in my opinion
How do you run the exhaust to the drivers side? Do you cut a hole in the frame or run it under the frame?
This is the only way to do it in my opinion
Do you recommend going catless or running high flow cats? Have you had the trucks dynoed after the exhaust installation for hp/torque numbers?
No we DO NOT cut frame to install our exhaust. If you chose to route it that way that's on you boss.