Famoso 11/17/2007 Results

[Trainman]

Hey Rice Eater....Thanks. No letup on the gas , full power shifts, throttle to the floor allthough I do use the clutch. Watch the shifter video on the Xmetal website....Thats me shifting. The truck puts 526 ft.lbs. the the rear wheels.

 

[Rice Eater]

Hey Rice Eater....Thanks. No letup on the gas , full power shifts, throttle to the floor allthough I do use the clutch. Watch the shifter video on the Xmetal website....Thats me shifting. The truck puts 526 ft.lbs. the the rear wheels.

Hmmmmmm, I've tried shifting with it to the floor....I have the gen IV also w/ ripstick and she doesn't want go all the time.....wanna come drive my truck and show me it can be done! Maybe my tranny is a little messed up??:dontknow:

 

[SrtBrad]

Hmmmmmm, I've tried shifting with it to the floor....I have the gen IV also w/ ripstick and she doesn't want go all the time.....wanna come drive my truck and show me it can be done! Maybe my tranny is a little messed up??:dontknow:

It's funny you say that because Trainman was paid by people to race there cars. I just wanted to see what an experienced driver would do in the 1/4 compared to an inexperienced stick driver at the 1/4 using the same truck. Trainman did .25 seconds better than my best pass on his first try with my RC.

 

[Trainman]

Rice Eater, I had trouble with my truck until I replaced the stock Slave and Master cylinder with the Viper Slave and Master cylinder kit from Boomer. Try that and then it's just a matter of practice. Did you watch the video on Xmetals website???

 

[Rice Eater]

I have the viper slave and cylinder kit....got it from ROE with the new centerforce. I guess i could try some more on motor but you gotta be damn confident doing that with nos....would hate to miss and hit the rev limiter!!!!! OUCH!!!