headers back from coater :)

[bmxam962]

Is it a requirement to use new gaskets

I was told you could reuse stock ones if you got them off with out any harm but most ppl I talked to sayed they tore apart when removed so I am just going to get new one's

 

[ZCx]

Thanks and shrink? I don't get it

tryin to make a funny, as in ya sent in long tubes & got back shorties:dancing2::dontknow:

 

[bmxam962]

tryin to make a funny, as in ya sent in long tubes & got back shorties:dancing2::dontknow:

Hahaha that is good one I am just slow lol :dontknow::dontknow:

 

[yellowfever#154]

They look good, get ready to melt the passenger side inner fender.

 

[NSDQ]

Is that due to the coating or the headers themselves?

 

[oldcolt]

Is that due to the coating or the headers themselves?

I trimmed both inner fenders when I installed my MOPAR Lt's. With the coating, the headers are still hot enough to melt any plastic they touch. Also make sure the wiring harness on the rear passenger side of the engine is secured up high.

 

[viperhauler]

these are bassani's... they won't melt anything...