Oggers
Full Access Member
I've been getting together all the info I'll need to get this wired in. The story so far.
I have:
Power RED
Tach GREEN
Ground Black
thanks to this thread
http://www.vtcoa.com/forums/f7/wiring-help-please-27101/
I have boost/vacuume hose thanks to this
http://www.vtcoa.com/forums/f7/paxton-almost-done-boost-gauge-38785/
The wideband sensor will be installed near the original lambda as per instructions from AEM
What I need help with is
Yellow: Boost analog output?
White: afr analog output?
Brown: Ground analog output?
Grey: Dash/instrument lights?
Where is the best place to splice these wires into? On the instructions it's the datalogger ems/fic?
Will I find the correct wires down by the clutch pedal? Where I'm going to run the power from?
With the tach wire I've read that if I connect the tach wire on the failsafe to the dark blue and white to the (PCM)it will only give me 2 cylinders is that something that I need to worry about?
Pin #1 is circuit K133 dark blue/white for coil control #4
Cheers, Charlie