Intake Bolts-Torque lbs???????

[SHU-DOG]

Anyone have the torque specs for the intake bolts?

Also everyone that has powdercoated or painted the intake-are you reuising the existing intake metal/rubber gaskets?

OR

Pirchasing new ones??

Also is there any kind of goop i need to put on them?

Thanks for the reply.

SHU

 

[rottenronnie]

You can reuse the gaskets.
10-15 inch pounds first round.
Final Torque- 95 inch pounds.

So LOWER bolts first (center out) drivers side (alternate front and rear) then
LOWER bolts, (center out) pass side (alternate front and rear).
Then UPPER bolts (center out, alternate), driver's side
then
UPPER bolts (center out, alternate), pass side.

No goop, just clean.

Ronnie

 

[SHU-DOG]

You can reuse the gaskets.
10-15 inch pounds first round.
Final Torque- 95 inch pounds.

So LOWER bolts first (center out) drivers side (alternate front and rear) then
LOWER bolts, (center out) pass side (alternate front and rear).
Then UPPER bolts (center out, alternate), driver's side
then
UPPER bolts (center out, alternate), pass side.

No goop, just clean.

Ronnie

Thanks Bro, Just got all the bolts in place finger tight.

NOW

Where in the hell do i get a 10 INCH / pounds torque wrench?

The ones at Harbor Freight start at 20 IN pounds.

WIll that matter starting at 20 inch pounds????

Thanks SHU

 

[LoveThisTruck]

Thanks Bro, Just got all the bolts in place finger tight.

NOW

Where in the hell do i get a 10 INCH / pounds torque wrench?

The ones at Harbor Freight start at 20 IN pounds.

WIll that matter starting at 20 inch pounds????

Thanks SHU

20in lbs is pretty much finger tight

 

[rottenronnie]

Thanks Bro, Just got all the bolts in place finger tight.

NOW

Where in the hell do i get a 10 INCH / pounds torque wrench?

The ones at Harbor Freight start at 20 IN pounds.

WIll that matter starting at 20 inch pounds????

Thanks SHU

You'll be fine with 20.....