KILLER AND CHEAP DROP

[bigike]

OK MY BUDDY BOUGHT A HEAVY DUTY FLIP KIT WITH C NOTCHES. THE DROP WAS TO LOW SO HE ONLY WENT 4" NO C NOTCHES. FOR THE FRONT HE CUT ONE COIL WITH A PORTABAND.

RESULTS AS PER HIM ARE THAT THE TRUCK HANDLES BETTER THAN EVER AND NOT A WORSE RIDE THAN STOCK AND NO BOUNCE.

AND THE LOOK IS EXACLY WHAT I'M GOING FOR SEE FOR YOURSELF

 

[moparracing]

looks good, how'd it affect the front end alignment ?

 

[SRT10VENOMOUS]

looks great.. proves u dont need to spend 700 to drop it

 

[bigike]

HE PUT IT BACK TO STOCK AND IT'S NOT THAT BAD OFF.

IT DOESN'T PULL AND I DON'T THINK HE WILL NEED TO HOG OUT THE HOLES TO GET IT PERFECT.

ALSO ON A HARD LAUNCH IT DOESN'T SHAKE AT ALL, SO HE MUST HAVE GOT THE PINION ANGLE DOWN RIGHT, OR CLOSE.

I KNOW ALOT OF PEOPLE WON'T LIKE CUTTING THE SPRINGS BUT IT LOOKS LIKE A GOOD ALTERNATIVE.

 

[bigike]

IT MADE MY TRUCK LOOK STUPID......................... AND CAME OUT PERFECT.

1.5+ IN THE FRONT 4" IN THE REAR. FOR 250 DOLLARS.

WITHOUT THE PERFORMANCE OF STINKERS.

 

[JTS VENOM PERFORMANCE]

be careful cuttem dont torchem heat will destroy the tension of the spring.

and watch how much ya cuttem too, they will settle another 1/2 to 3/4 inch after a little while and in a couple years they will actually loose some tension too.

I did it in 04 mine has dropped an inch over when I first done it

so be careful bo, but loooks killer man!:rock:

 

[Yellow venom]

Looks great! How much did he cut off front coils?

 

[bigike]

One full coil was cut. Cut with a band saw and cutting fluid

Stinker this is only to hold him over until your kit comes. And he gets the money

 

[JTS VENOM PERFORMANCE]

LOLOL Hey bo, Iam all about saving a buck or two trust me

dont blame ya a bit, it works, and good deal on the band saw:rock:

I've seen a few will take a torch and either cut a coil off or use the heat to make the springs drop, and LOLOLOL they really eventually drop!LOLO

He did good man, if ya look back I think it was Roz I told him he could do this:rock:

but Ike , got a Q, what rear flip did he use, I can get a adjsutable pinion flip for $280 and I think a simple flip for $100 i think it was.

the reason I ask Is I got one guy thats well had alot of problems with his flip, I mean big ol probs

 

[bigike]

I don't know it's really heavy duty.

especially compared to my MG's kit!

The adjustable pinion for 280 I'll buy that one.

I just need to get alittle more road time and I'll buy that and the fire/ice bar