seethrough
Member
Went to get in the truck to take it to the chassis shop and all I get is CLICK CLICK CLICK from the starter and no cranking. Trucks been sitting a few weeks so I figure it needs a jump. Tried jumping it, charging battery and even replaced the battery still the same. Took a voltmeter to the battery with jump start charger on it and it drops from 14.5 to under 9 when the starter tries to engage. Checked my battery connections and they are hot to the touch so I know there is massive amounts of current and not just a battery issue. Put a socket on the crank and tried turning the motor over by hand thinking the starter gear was worn and wedged with the flywheel. Can't turn over the engine even with a 3' cheater bar. I didn't give it a lot of pressure but enough that it should have budged a little. Loosened the bolts to the starter and played with it but it is not binding. I started pulling plugs and scoping the cylinders to see if I have any binding but the heatwave we have finally got to me after 3 plugs and I came back to the AC and cold beer to ponder on this. The hot starter wires lead me to believe the starter is working but the seized engine isn't giving under the starter power. I plan on pulling all the plugs and seeing if I can turn the motor over without any compression and make sure that the cylinders are clear. Any other input would be appreciated - Not that I don't like pulling a plug or two and then stopping for a beer but that usually ends up with me frustrated and not thinking clear enough to fix the problem.