Need some pics
- Thread starter ccm
- Start date
What do you need to know? QC or RC?
Hold on will get you a few pics
having puter probs chris , hold on bro
the front
raise up the front by the lower control arm.
remove the nutt holding on the spindle, and hit the spindle with a hamer or you can use a pickle fork to separate the spindle from the lower control arm.
remove the front shock, and the sway bar link.
pick up on the spindle and set it towrds the rear of the arm.
then slowly lower the lower control arm.
remove and replace spring, and reverse directions.
then cut off the oem mount for the front bumpstop
and replace with new bumpstop.
raise up the front by the lower control arm.
remove the nutt holding on the spindle, and hit the spindle with a hamer or you can use a pickle fork to separate the spindle from the lower control arm.
remove the front shock, and the sway bar link.
pick up on the spindle and set it towrds the rear of the arm.
then slowly lower the lower control arm.
remove and replace spring, and reverse directions.
then cut off the oem mount for the front bumpstop
and replace with new bumpstop.
Attachments
the rear
raise and support the rear of the truck safely
best by the spring itself
the put a jack under the rear axle
remove the bolts from the u bolts and remove u bolts
now sometimes I have heard the rear end is tough to separate from the springs, it does come apart,
DO NOT REMOVE THE SMALL BOLT GOING THRU THE SPRING PACK
then install the blocks , locating them with the pins, install new u bolts, tighten , leter down.
recheckthe ubolts after the first 100 miles for tightness.
oh and the last pic? you guys thought I was a guy?
raise and support the rear of the truck safely
best by the spring itself
the put a jack under the rear axle
remove the bolts from the u bolts and remove u bolts
now sometimes I have heard the rear end is tough to separate from the springs, it does come apart,
DO NOT REMOVE THE SMALL BOLT GOING THRU THE SPRING PACK
then install the blocks , locating them with the pins, install new u bolts, tighten , leter down.
recheckthe ubolts after the first 100 miles for tightness.
oh and the last pic? you guys thought I was a guy?
Attachments
no prob bro, glad it finally arrived sir:rock: holla if you need any help at all sir
Support Us
Become A Supporting Member Today!
