new look

[Ironhead]

 

[REPOMAN1]

Looks good man .

 

[ViperJeff]

Terry is going to want it back

 

[Ironhead]

Terry is going to want it back

tell her i did way to much work on it to get it here lol

 

[ViperJeff]

tell her i did way to much work on it to get it here lol

I know she's happy it went to a good home

 

[Dom426]

love the calvues on there !!!!!!!!

 

[Sammy11]

looks awesome !

nice 'n low...:rock:

 

[Yellow venom]

Looks killer! The tailgate handle is a sweet touch!!:drool: Sure looks cleaned up with the mirrors and handles colour matched! :rock:

 

[Slitherbeast]

Damn ! Albino truck! Looks awesome!!! is she sportin' the Strykers?

 

[FATJACK]

Beeyoooteeful...

 

[ZCx]

:rock::rock::rock:very sharp:rock::rock::rock:

 

[raymondwebb]

damn!!! only thing that could make that sexier would be if it were black instead haha

 

[Yellow venom]

damn!!! only thing that could make that sexier would be if it were black instead haha

I would disagree with that! Lol :chain:

 

[Midnight Runner]

Looks great.

 

[Theol55]

Very Nice!

 

[Outlawl]

IS tghat the JTSVP extreme lowering kit?

 

[Ironhead]

IS tghat the JTSVP extreme lowering kit?

No its the Ironhead special lowering kit ,,i made my own lowering blocks at work on a Bridgeport out of a block of aluminum , i made them for a 3 1/4 in drop and i had a set of front springs i trimmed down from my old dodge 3/4 ton truck ,,,i did buy a set of urethane bump stop from stinkolaman for the front and rear then i took it in to a front end shop here in Houston and had them install a set of eccentric bolts and hardware on front control arms for easier front end alignment ,,

 

[ARRESTmeRed04]

No its the Ironhead special lowering kit ,,i made my own lowering blocks at work on a Bridgeport out of a block of aluminum , i made them for a 3 1/4 in drop and i had a set of front springs i trimmed down from my old dodge 3/4 ton truck ,,,i did buy a set of urethane bump stop from stinkolaman for the front and rear then i took it in to a front end shop here in Houston and had them install a set of eccentric bolts and hardware on front control arms for easier front end alignment ,,

Nice, how does it ride with the 3/4 ton springs?

 

[Ironhead]

Nice, how does it ride with the 3/4 ton springs?

just like stock i cant tell the diff and i dont have to worry about bottoming out on a bump,,when i measured the diameter of springs they were almost the same a little bit larger diameter ,,just the 3/4 ton ones were higher than ours are,,i did not want to cut my oem ones just in case it did not work out,,,o and the cost of my drop kit ,,about 200 bucks including front end alignment ,,cant beat that bubba

 

[Midnight Runner]

You working on that motor yet?