As some of you know, the engine is out of my truck. I will post the efforts to change that here, if the RESPONSES FOCUS ONLY ON THE REBUILD. I will ask the mods to remove any post concerning previous work done by others. I have much bigger fish to fry than to worry about the past.
In January, the engine started to knock. I took it in and had the valve covers pulled, but we did not find the source. When we restarted, the knock was able to be localized to the bottom end. So the engine was pulled. During pulling water was found in the oil, so we started searching for the source. AS there was not oil in the water at the oil change at 400 miles or 600 miles. The tear down did not find a smoking gun, so the heads and block were hydroed. Both passed. I should have a estimate for parts and labor by the end of the week. We will see if it is within my ability to get it done with my higher priorities.
Please remember my request in responding.
In January, the engine started to knock. I took it in and had the valve covers pulled, but we did not find the source. When we restarted, the knock was able to be localized to the bottom end. So the engine was pulled. During pulling water was found in the oil, so we started searching for the source. AS there was not oil in the water at the oil change at 400 miles or 600 miles. The tear down did not find a smoking gun, so the heads and block were hydroed. Both passed. I should have a estimate for parts and labor by the end of the week. We will see if it is within my ability to get it done with my higher priorities.
Please remember my request in responding.