Question for Justin (JMB)--CAI Design

[TJ-SRT10]

Justin,

Was wondering if during your designing phase of the CAI, did you consider
making the filter & pleum to angel down next to the radiator instead of remaining on the verdical plan or do you plan on doing a diff variation sometime later? I am planning to get one, also, I noticed on one install that
the oil catch can line had a kink in it (was painted purple--(Juan's truck) saw it in a diff thread). Is that normal or just an alignment problem? :dontknow:
Keep up the great work man. Thanks. :rock:
Chat Later!

Tony:burnout:

 

[RedRamRules]

In my installation I didnt really put much attention to the instructions. I just went with what looked like the way to install.

In regards to the tubing, I think I may switch to a thicker rubber or differnt type of tubing. The tubing supplied is easy to kink, to setting it up perfectly may be a problem. Thats just my POV, I'm sure there are others who have installed it with no issues.

 

[RedSrt007]

I installed my JMB breather setup which included the same tubing. It does seem a little on the thin side, but I have no issues with it kinking; the quality of the product overall was one of the best I've seen.

-Red

 

[JMB Justin]

Tony I can make up pretty much whatever you want if you want something custom, I chose the minimum amount of bends possible when designing it (also keeps the cost down). On the tubing, it will kink if its too long, you may need to trim it slightly.
Thanks
Justin