azpyroguy
Full Access Member
Well.. at least I think I did...
I installed a new belt... which was a real pain in the a$$.
But before doing so I took my drill and wire wheel and roughened up the surface of the S/C pulley... its not so rough.. buy now you can see a surface for the belt to grab on to.. much like a surface that you would get when you media blast something.
I had the all the parts off in the area fixing my A/C again... (sigh...).. so I figured what the hell go ahead and replace the belt should not take too long... well what started out as a 1 hour deal turned into a 3 hour mess... but I got it done...
It does not seem to slip or squeel now.. but I will take it out over the next few days and give her hell and see if it slips...
I installed a new belt... which was a real pain in the a$$.
But before doing so I took my drill and wire wheel and roughened up the surface of the S/C pulley... its not so rough.. buy now you can see a surface for the belt to grab on to.. much like a surface that you would get when you media blast something.
I had the all the parts off in the area fixing my A/C again... (sigh...).. so I figured what the hell go ahead and replace the belt should not take too long... well what started out as a 1 hour deal turned into a 3 hour mess... but I got it done...
It does not seem to slip or squeel now.. but I will take it out over the next few days and give her hell and see if it slips...
