I spoke with Sean Roe today, GREAT GUY! I have yet to make a purchase from Roe as I have made purchases from a few of our other vendors. Called him in regards to the new rumored 710R cam... Well, its in production and sounds impressive! Sean says they upgraded it so its more truck friendly and brought the torque on 500rpm's earlier! I have begun my N/A build (very early stages) and am thinking I might give this cam a shot. Sean, thanks for being so informative. To everyone else- Sean was also very informative and educational on products that I am not purchasing from him... That's when you know you're dealing with a good guy!
ROE RACING
- Thread starter stealth78
- Start date
Lol! That makes two of us! Build wise nothing crazy, staying on stock rotating assembly. Heads have been sent out to a local guy here in MA, intake manifold has been sent to the Doctor down in Texas
, definitely going with thinner head gaskets, already have my slow bleed lifters, and have not yet made an executive decision on a cam but there is a couple that I am leaning towards. All in all, I will be happy with anything over 550whp!
Lol! That makes two of us! Build wise nothing crazy, staying on stock rotating assembly. Heads have been sent out to a local guy here in MA, intake manifold has been sent to the Doctor down in Texas
With ported heads, intake, cam, and the compression bump, you'll be well over 550rwhp!
Snake_Charmer
Full Access Member
We are building similar cars and I too had a great convo with sean about the 710R cam. I am starting mine within the next few weeks. I dont have to wait till spring
Support Us
Become A Supporting Member Today!
