Soft Feeler FS/FT: 05' RC H/C (Fresh engine)

[faslane505]

hey...not sure if i really want to do this...but i might be getting into a venture soon and would have to get rid of the truck...gonna need a DD and dont think the truck is what i wanna do that with. i do still have a very small lien on the truck...which i can pay off if we make a deal and have the title the next day...so thats no problem. i would like an even trade or trade down...

possibly looking for a truck or suv. Looking for a trade in the $26k area

My truck:

Black 05' RC

Fresh engine ( 0 miles)

Short Block: Honed and decked. all new rings and all new bearing (all purchased through Stinker) fully balanced and assembled. stock internals

Heads:

Fully Ported and polished.
H/S rockers (brand New)
Manley Valves (brand new)
Comp Springs (brand new)
Comp Push Rods (brand new)
Milled .020''
reshaped and polished combustion chambers

Full exhaust. bassani ceramics and catless...magnaflow catback...SCT Tuner..B&M shifter

have receipts for roughly $9k for engine alone. (over $6k in the heads)

tony is sending me a new oil pump this week and thats the last thing needed for the truck. if we make a deal....ill leave the tuning to the new owner...
\
all fluids (tranny, rearend) have all been flushed and replaced.

body is in great shape...small chip on front fascia. but thats it.

let me know what you got...

Thanks guys

 

[JeffBoyette]

Damn hate to see another one go. Clean truck man. Who did your port and polish, and does it have the stock cam in it? Best of luck to you on your new venture btw. Im sure you will buy another one when the time is right. I sure did.

 

[faslane505]

It's a custom comp cam. Flowed the heads and had it custom done

 

[JeffBoyette]

Can't wait to hear it run!

 

[chargerman426]

Any reason why you didn't forge the bottom end while you where in there?

 

[faslane505]

Any reason why you didn't forge the bottom end while you where in there?

never had any notion to go any further than N/a...so the stock bottom end is plenty strong enough for any n/a application...as long as your tune is right. i concentrated my funds on making the heads a bad ass as i could. and rebuilt the bottom end to make it basically new.

 

[faslane505]

Can't wait to hear it run!

me either...its been 40 months since its been driven

 

[faslane505]

bump..