Did anyone end up doing this?
I will, in time, but looking at the prices, you could get the aluminized steel for literally HALF the cost of the polished stainless...meaning you could use the aluminized until it fell apart, and then replace them with brand new ones and start all over again-for what it would cost for ONE set of polished stainless. Or you could change your setup at that point and start with something new with an extra $160 to start off with...any reason why I shouldnt go this route??
It is it possible to use 2 of the 2 1/2 in/outlet ones in place of the oE muffler? I'm installing JMB catless mids soon and the rest of the OE exhaust is still solid.
I will, in time, but looking at the prices, you could get the aluminized steel for literally HALF the cost of the polished stainless...meaning you could use the aluminized until it fell apart, and then replace them with brand new ones and start all over again-for what it would cost for ONE set of polished stainless. Or you could change your setup at that point and start with something new with an extra $160 to start off with...any reason why I shouldnt go this route??
I'm by no means an exhaust expert, but if you are concerned about the aluminized steel falling apart on you, you could always paint the mufflers with some exhaust paint to help protect them from the elements.
ya can compromise, go unpolished & have great life out of them & way better resale/trade value later on:dontknow::rock:
i love stainless steel:rock::rock::rock:
I wish I had a under picture of the spins on the truck. I had them stacked sideways next to eachother.
Yeah I ran 2 of them. The video does not justice on how they sounded in person. who ever buys a set will be happy.
Do u have to put an x pipe before the mufflers??
I do but mine is set side exit not sure it will help
Yea that probably won't help unless you're offering to do mine...:drool: