truck going under the knife today

[eddie102870]

well finally got time to do a little work on her and finally get the cal tracs installed i got for my birthday in october. Boomer says 3 hour install time in the real world. i will let yall know how it goes.

 

[FlyingLow]

Don't you have to have access to some type of press for the bushings? If I could leave the county I would drive up and give you a hand. Let us know how the install goes and what you think about the caltracts.

 

[ViperTruck2933]

well finally got time to do a little work on her and finally get the cal tracs installed i got for my birthday in october. Boomer says 3 hour install time in the real world. i will let yall know how it goes.

Shoot it usually takes me 3 hrs just to unwrap stuff I get from BOOMER. Better have all day for that install, lol.

 

[NBT]

well finally got time to do a little work on her and finally get the cal tracs installed i got for my birthday in october. Boomer says 3 hour install time in the real world. i will let yall know how it goes.

Good Luck Eddie... your going to love em' :rock:

 

[eddie102870]

got one side on in a hour almost finished worst part is getting bushing out, used a head wrench and all is well in the universe, got about 30 minutes worth left. will keep yall posted.

 

[FlyingLow]

I didn't realize you were doing it right now. Hope the rest goes easy.

 

[eddie102870]

ok got them done boomer quoted 3 hrs we got her done in two. i guess we were hitting on all cylinders today.pretty good for some rednecks. adjusted them 1 full turn after they hit the springs. felt pretty good on asphalt. will test them at the track this sunday afternoon.

 

[eddie102870]

Don't you have to have access to some type of press for the bushings? If I could leave the county I would drive up and give you a hand. Let us know how the install goes and what you think about the caltracts.

we have a press but its in storage since we never use it. got it done with a bfh and a torch. didnt take long at all.

 

[FlyingLow]

we have a press but its in storage since we never use it. got it done with a bfh and a torch. didnt take long at all.

What is a bfh?

 

[Manic]

Big F***'** Hammer

 

[FlyingLow]

Big F***'** Hammer

Riiiiiight!!! I wasn't even close.

 

[V10ToGo]

Do Caltracs help the QC launch? Are they worth the cost and effort? And what do they cost?
So many questions - so little time... Thanks, guys.

 

[FlyingLow]

Do Caltracs help the QC launch? Are they worth the cost and effort? And what do they cost?
So many questions - so little time... Thanks, guys.

The best I have been able to tell Larry is that they are worth it. The cost of them is not too bad. But I have yet to get them, so I can't give you a real good answer.

 

[eddie102870]

What is a bfh?

big fuckin hammer, oops seen that was already answered. will let you know on the launch sunday gonna try them out.

 

[mauiSRT/10]

Looks good Eddie. How come you have a shifter light for a QC? You rowing gears?

patrick

 

[eddie102870]

bling factor