rare03srt10
Full Access Member
Since i put a SRT-10 engine into a dodge ram 5.9 L i can tell you that EVERYTHING is different between the trucks as far as drive train and wiring goes lol
Since i put a SRT-10 engine into a dodge ram 5.9 L i can tell you that EVERYTHING is different between the trucks as far as drive train and wiring goes lol
i was just told by two different junk yards that the rear axle shaft is the same from like 1994 to 2008 dodge ram 2x4 or 4x4 i may have got the years wrong but it was something like that. and they said the lower control arms are the same as the dodge durangos, i will have them pull one off and i will match it up. the upper control arm is SRT 10 only for sure both yards told me that.
I bought as axle shaft from rockauto. the wheel flange isn't as thick but it is the right size. I havn't used it yet. I was to lazy to replace my bent one and now noticed i don't need it anymore! So it sits on a shelf
Since i put a SRT-10 engine into a dodge ram 5.9 L i can tell you that EVERYTHING is different between the trucks as far as drive train and wiring goes lol
Much props for that project
I have fit plenty of SRT10 parts on to a 1500, but I wouldn't try to do it the other way round...alot of junkyards are as unknowledgable as most parts store people.
agreed..... i have gotten a few parts from advanced auto, if it is a motor part i have to tell them it is for a 2004 viper and i got an axle seal but had to bring mine in to match up. There computer has SRT 10 listed but all the parts are for a regular 1500. i am having great luck with the dodge dealer though......lol