WTB OEM FLYWHEEL

[Ironhead]

wtb oem flywheel ,,,new dont want a used one unless it came out of a new truck with real low miles on it,,??

 

[Ram From Hell]

Man. Just threw one away a couple days ago.

 

[TNVIPER]

Got one with less than 100 track miles....was always carefully shifted and never driven when the temp was over 87 degrees outside....make reasonable offer and I will pay shipping as long as your reasonable offer is more than $300.............I also have this bridge that has been in the family for over a century......:marchmellow:

 

[FATJACK]

Damn Larry, that looks like the one outta my truck....where is that bridge located???

 

[Ironhead]

Damn Larry, that looks like the one outta my truck....where is that bridge located???

any fish in the water under it

 

[dnz28]

I have one you can have, its rusty from sitting, i think it has 20k miles so it would need resurfacing looks kinda like the one above but not near as bad(rust covering it now)

i will be going towards north houston saturday and travel to south houston every day so if you interested ill drop it off to you or meet you if your interested

 

[Ironhead]

thanks but i was hoping to get a new one from a dead project repo or crash that never got installed ,,, jack learned me that if not when im ready i will buy new if i have to.

 

[FATJACK]

thanks but i was hoping to get a new one from a dead project repo or crash that never got installed ,,, jack learned me that if not when im ready i will buy new if i have to.

Boy you are a slow learner, nothing wrong with a used flywheel, it can be lightly machined and will be good as new. I think new ones are only about 130.00..

 

[DevilDawg3097]

shipped from roe to chicago it was 145 or 150. He was the only one that had one when I look. Be cheaper to you. Just go new and no headaches or worries.

 

[TheMoparConnection]

if you want a new one i can have it billed out for you at my other dealer and you can pick it up... figure 150.00 with tax

 

[yellowfever#154]

if you want a new one i can have it billed out for you at my other dealer and you can pick it up... figure 150.00 with tax

It will cost about half that to have them machined, just buy yourself a new one. The flywheels that I deal with at work are anywhere from $1500-$2000 new so we always will have them machined.