Xmetal TB sticks

[Begood]

against a stock manifold Bill.. yes.The Roe is flat surface , no groove and rubber gasket... instructions ask for a tiny seal of silicone ...

I didn't realize you using a Roe, my mistake.

Bill.

 

[JTS VENOM PERFORMANCE]

Ok crazy question, maybe i missed it:dontknow: but have ya called Sean roe?

 

[oldguysrt10]

I'm about ready to buy this item. Not sure if I should from all the neg. vibes I been getting. Which to choose from, X-metal? Roe? I guess there are one or two others as well. I would like to get one that don't stick though. Any other thoughts from anybody?

Jim

I bought the Roe, read the directions, waited until I had plenty of time to do the installation without being rushed, followed the directions, and completed the installation in less than an hour (don't remember for sure but probably closer to 30 minutes). I tried to make it more difficult that it was but just couldn't find a way. It's been in for 6,000 miles with no problems. I had no alignment issues. I didn't use the paper trick.

No doubt folks have had positive experiences with X-Metal too.

oldguy

 

[belgiumbarry]

Ok crazy question, maybe i missed it:dontknow: but have ya called Sean roe?

hard to call Sean with a Xmetal problem...:dontknow:

 

[JTS VENOM PERFORMANCE]

hard to call Sean with a Xmetal problem...:dontknow:

oh...oops

 

[belgiumbarry]

oh...oops

thanks Stinker for your professional info on this subject ...

 

[amtrucker22]

thanks Stinker for your professional info on this subject ...

:rofl: :rofl: :rofl: Now that is funny