Recent content by mikeu220

Hi guys, Can any one help me out with locating a camshaft sensor for my 2004 SRT10. I have been searching since November and no luck so far. Mopar discontinued it and apparently it's no where to be found. I would greatly appreciate it if anyone can point me in the right direction so i can...

No traction bars - YouTube

Stifflers Long Bar Test 1 - YouTube Found some "Stifflers"videos on Youtube

Haha sorry 'bout that. Kinda shy. I am going to the dyno after I put the cam in and ill make the two pulls again. Open and closed. and post em.

Thanks guys! I really appreciate all the info and advice.

Haha Driver mod. I have a 04 with the 4.10's. Probably wont be doing the 4.88's, too much of a pain to change the whole thing. But deff the 4.56's and the cryo frozen sounds like a solid decision. And a lot of practice.

Thanks for the Advice. Will try that next time. Just thought I could just stomp the peddle and I would get low 13's the trucks power. I need to practice...alot Haha.

Ok I guess im a little behind. What is cryoed? ad where would they do that? I was looking into different ratio's in the future like a 4.55 or the 4.88. (i think those are right?) But wanted to get traction first. What wheels are you using the DR"s with?

Haha dont worry about bashing, I got thick skin. tell the truth I wasn't completely comfortable. It wasnt just wheel hoping in second. The rear felt like it was sliding to the right. I wasnt powershifting, too chicken for that! Haha. I would let off the gas and then shift. Now that I see your...

Are those MH390 40 17 DR safer than the cheater slicks? I mean Axle safe? They look pretty good!

Yea my shifting is pretty slow compared with you guys. Second gear I do wheel hop. I have to let of the gas so i do not fish tail, then get back on it. Im also shifting at around 5300-5500rpm and poping the clutch. How would i ease off the clutch as such high rpms?

What tire set up are you guys running. ei cheater slicks and wheels?

im looking at the slips right now and my best one was 60ft time@ 2.502, vehicle speed @103.21 and time was 14.083 other times where 60ft from 2.455-2.826 top speed 98-101. and times where 14.3-15.3

Hows it going ARRESTmeRed04? Put me on the list man. I want to try 'em out.

Hi guys. I need some advice for better traction. I went to the drag strip last Saturday and was pretty bummed out about the numbers I ran. 14.5 was my best 1/4mile time. (Averaging 15secs) This is my first time at the track and had to run a few passes (like 12) to get the trick of it. My best...