Anybody Want To Sell A Driveshaft Loop??

[FATJACK]

Moes are out of production on them and doesn't think he will build any in the near future.

 

[BLWNSRT]

Sorry I already sold mine to yellow446

 

[TNVIPER]

Sorry, I never did buy one...

 

[Begood]

Can't you use a universal one from Jegs?

Bill.

 

[FATJACK]

Can't you use a universal one from Jegs?

Bill.

I don't think so Bill because where they have to mount. The actual mounting point is about 10" in front of where the loop needs to go.

 

[bigredv10]

Moes are out of production on them and doesn't think he will build any in the near future.

What no welder? Got a pic or deminsions? Im sure one could be made fairly easily

 

[FATJACK]

What no welder? Got a pic or deminsions? Im sure one could be made fairly easily

Could sure use a pic if anyone has one. Ours have about a 10" extension on the upper mount. Would be a little difficult to fab I would think.

 

[JRSVIPR]

Jack, If Tony can not get you one.

http://moesperformance.com/index.php?main_page=index&cPath=105_112

 

[FATJACK]

Jack, If Tony can not get you one.

http://moesperformance.com/index.php?main_page=index&cPath=105_112

Yeah, already tried that Moe is out of stock and does not plan to build any in the near future. Thanks though.

 

[SrtBrad]

Shoot Ron at Cherry Performance a pm. He might be able to build these for us.:dontknow:

 

[Brat]

Shoot Ron at Cherry Performance a pm. He might be able to build these for us.:dontknow:

:rock::rock::rock::rock::rock::rock::rock::rock::rock::rock::rock:

 

[FATJACK]

Shoot Ron at Cherry Performance a pm. He might be able to build these for us.:dontknow:

Good idea Brad, just sent him a PM. Thanks

 

[RAMDUDE]

Jack give me specs and a picture and I might be able to tig one up for ya

I been on kinda busy at work, I am looking into some pipes for a member on here now also.

 

[FATJACK]

Jack give me specs and a picture and I might be able to tig one up for ya

I been on kinda busy at work, I am looking into some pipes for a member on here now also.

The only pic I can find is on Moes Performance website and it is small

 

[LMSVPR]

http://www.vtcoa.com/forums/showthread.php?t=24463

this might help as far as pix a bit bigger :dontknow:

 

[moparracing]

what he said.

 

[HaroldD]

I built them for my QC so I could run on Bonneville and was going to make some up for folks, but I've been slammed at work. I've modified the front design to hang off the back of the trans tailshaft where the two bolts for the braces go. No pics of this. Messing with putting it under the carrier bearing mount was a bad idea - that's super-sensitive to angle.

http://vtcoa.com/forums/showthread.php?t=36926&highlight=driveshaft+hoop

Someone is welcome to use my design - no patent here. Wish I had time...

 

[1fast10]

I bet pleny people do

 

[viperhauler]

The only pic I can find is on Moes Performance website and it is small

what the hell you need a driveshaft loop for?:aetsch::aetsch::aetsch::aetsch:

 

[1fast10]

hahaha I just caught that