Hey guys,
I was looking at getting a classic white Hurst ball shifter part#: 530-163-0040 @ Jegs and while I was there I was thinking I could get a Hurst stick and put it on my Gen-X shifter, not sure if new holes will be needed, should be OK. Anyhow, I am looking at this Hurst shifter, part#: 530-538-4084 Longer throw, yes I know
but it's just so classic and I have always loved the look of the HURST logo on the levers, it's so Mopar. My question, is the shifter lever handle lean/bend to the LEFT (LHD) or to the RIGHT (RHD)? If it is LHD can I just simply bolt it in so the bend is towards me in a RHD vehicle, easier reach? Or can you only put these levers in one way? Hope this makes sense.
Cheers,
Carl
I was looking at getting a classic white Hurst ball shifter part#: 530-163-0040 @ Jegs and while I was there I was thinking I could get a Hurst stick and put it on my Gen-X shifter, not sure if new holes will be needed, should be OK. Anyhow, I am looking at this Hurst shifter, part#: 530-538-4084 Longer throw, yes I know
but it's just so classic and I have always loved the look of the HURST logo on the levers, it's so Mopar. My question, is the shifter lever handle lean/bend to the LEFT (LHD) or to the RIGHT (RHD)? If it is LHD can I just simply bolt it in so the bend is towards me in a RHD vehicle, easier reach? Or can you only put these levers in one way? Hope this makes sense.
Cheers,
Carl
