Hm, there is not to much free play I think...
I think I have to bring the truck back to the installer!?
What is a crush washer? And what do you mean with stack?
Sry dude, my english is not so good...
Padre
Hi guys,
I just got my rear axle back installed.
The rear axle ratio was changed from a transmission company to 4.88.
Now I have a loud noise from the gearbox.
Not at full throttle but when I drive slowly and then very little gas give ...
is such a known problem?
I'm desperate ...
maybe two or three coats of epoxy are needed.
on the last picture is now a layer carbon fiber and epoxy coating on it.
now I'll apply another layer epoxy and then let it dry properly.
Then I'll grind it with a eccentric grinder and I hope to get a smooth surface for spaying clear lacquer on...
Hi Guys,
I love the carbon look and so I came to make the idea itself.
real carbon parts are very expensive, mine is better off ...
it is not so easy, but it looks the same.
That was my first try:
The tank from my gokart...
bevor:
after with clear coat finish:
I...
first of all have you to thank you for your help! :rock:
How much HP do I get with an another camshaft actually?
I can not believe that the oem pistons/rods are such a crap.
My first car was a Fiat uno turbo. I took a normal 1.6l block, the compression ratio pistons were shot on...
First of all I will do the 4:56 rear end...
Sooner or later I have to change pistons an rods.
Basically I have do this job right. Otherwise I would not be happy...
But I thought I can go with the oem pistons and rods to 700-750hp without getting problems. :(
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.