FS: Forced Induction SRT10 Partout, OEM parts and Engine parts

[Yellow venom]

PM sent

 

[JMB Justin]

Hey do you still have the heads?

PM sent

PMs replied

 

[JMB Justin]

Oliver Billet rod set, stock length, stock big end, .927 pin, good for 2000+HP $1000
Diamond Piston set for above rod set 8.8 compression, needs one piston replaced $100
Cloyes Hex adjust timing set $180
Stock Timing set $40
Aeromotive -10AN in/out filter $60
OEM throttle cable $15
OEM brake booster $5
OEM Throttle body complete $60
OEM Throttle body housing and blades $15
OEM Power adjustable pedal set, Auto/gas $10
OEM power adjustable pedal motor $5
OEM oil pickup tube $5
OEM Air bag module $5
OEM rear axle ubolt set $5
OEM coil (4 cyl one) $5

 

[JMB Justin]

Updated list:

-Suede covered headliner and door sill set, very nice $150
-Single nozzle Nitrous express kit with big carbon solenoids, no bottle or feed line $175
-Roe water injection control box $10
-Big Rotor/High volume/pressure oil pump and front cover assembly PENDING
-Diamond pistons, one bad, 4.040 bore, .927 pin, 8.8 Comp $100
-Stock fuel rails modified with -6 ends on them for a aftermarket fuel system.
Powdercoated reflective chrome, never installed since modified/coated $175
-170 Tstat $20
-Candy red T-stat housing with swap for your stock $30, $130 outright
-Torque limiter setup, worked great even with huge power $75

 

[JMB Justin]

N20 solenoid set sold

Also have:
SS front brake lines $30
Autometer triple guage pod for center cubby on dash $10

 

[noid]

N20 solenoid set sold

Also have:
SS front brake lines $30
Autometer triple guage pod for center cubby on dash $10

PM sent on lines

 

[Brat]

If you dont take them I will.

 

[SRT2SLOW]

How long are the oem u bolts ??

 

[JMB Justin]

Ill have to measure, they are only long enough for the spring and axle, no drop blocks would fit.

Brake Lines sold

Ive also got a good used billet stock size crank pulley for stock dampners $50, its about .5 # lighter than OEM.

Justin

 

[JRSVIPR]

How long are the oem u bolts ??

These are OEM from a R/C.

 

[JMB Justin]

Thanks

 

[NSDQ]

payment sent on crank pulley. Thanks Justin.

 

[JMB Justin]

OEM throttle body sold, Oil pump sold, crank pulley sold, brake lines sold

 

[04rcmoneypit]

Justin, I know it wasn't on the list but did you sell the coils that mounted on the vavle covers?

 

[SrtBrad]

No sir

 

[yellowfever#154]

Justin, I know it wasn't on the list but did you sell the coils that mounted on the vavle covers?

Theres a little more to the big picture to get the single coils, than just the coils

 

[JMB Justin]

No they will be reused

 

[JMB Justin]

Updated list:

-Suede covered headliner and door sill set, very nice $150
-Roe water injection control box $10
-Stock fuel rails modified with -6 ends on them for a aftermarket fuel system.
Powdercoated reflective chrome, never installed since modified/coated $150
-170 Tstat $20
-Torque limiter setup, worked great even with huge power $75
Oliver Billet rod set, stock length, stock big end, .927 pin, good for 2000+HP $1000
Diamond Piston set for above rod set 8.8 compression, needs one piston replaced $100
Cloyes Hex adjust timing set $180
Stock Timing set $40
Autometer triple guage pod for center cubby on dash $10
Aeromotive -10AN in/out filter $60
OEM brake booster $5
OEM Power adjustable pedal set, Auto/gas $10
OEM power adjustable pedal motor $5
OEM oil pickup tube $5
OEM Air bag module $5
OEM rear axle ubolt set $5
OEM coil (4 cyl one) $5

http://farm9.staticflickr.com/8178/8063352651_6bd42aef9b_z.jpg[/IMG
[IMG]http://www.jmbperformance.com/photos/DSC_2820.JPG

 

[SrtBrad]

Nice stuff great prices!!!

 

[ViPeR_PiLoT]

PM sent on headliner and sills