Standard procedures to flush coolant.
- drain cold coolant (safety) by turning valve underneath radiator, driver's side
- follow directions on kit if using one
- add water, run engine around 10 mins (you can turn heater on too)
- drain water
- close valve
- add new coolant/distilled water/water...
Dr Lee, about your PM. I have VEC3 and harness as described above for a forum member. Wasn't really putting it up for sale as a for profit item. Been a backup for me. But I saw a forum member needing one. So I posted it.
If you are looking for a complete setup with...
Yeap, still have it sealed/wrapped. Also, have a repaired harness from Roe Racing, signed document that it is repaired.
I have never installed this VEC 3. Mine was a VEC2+, so I was going to have to do the harness at the same time for a swap out.
It's still sealed in bubble wrap from Sean. I was trying to isolate an issue and figured it out before swapping VECs. I paid 400 for the extra Vec. Probably about a 100 for Sean to test it and send back.
It's just sitting in a box in my house. Let me confirm I have it here in MD now and...
http://www.vtcoa.com/forums/f7/pulling-engine-let-me-know-if-there-anything-you-want-measured-picture-8000/index6.html
#235
Had it installed for some 5 years now, no issues, only peace of mind.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.