Cleaned up my pistons

[ramv10]

I'm in the process of doing a NA build (heads & cam). Still have not received them, but heres where i'm at. Decided to clean up the carbon build up from my pistons.

All the pistons were like the left one (31000 miles)

 

[Ironhead]

what cam ,what heads ???/ inquiring minds want to know

 

[jman08]

what cam ,what heads ???/ inquiring minds want to know

Yes inquiring minds lol

 

[ramv10]

Striker

 

[Ironhead]

Striker

Cam????

 

[ramv10]

Cam????

custom grind 232/234 .598" lift

 

[srt91]

Just a note on lifters / just make sure u put the lifters with hole up / am carbon on pistons build compression / compression make hp / an with that many miles u should put rings an bearings in it / would be more power gain

 

[srt91]

An make sure u degree the cam In / I went thru 2 custom grind before getting that was right

 

[rottenronnie]

Striker

GOOD CHOICE !!

 

[hawk02]

Nice........

 

[rottenronnie]

I'm in the process of doing a NA build (heads & cam). Still have not received them, but heres where i'm at. Decided to clean up the carbon build up from my pistons.

All the pistons were like the left one (31000 miles)

If you remove your knock sensors to get the bugs out from under and around your coil packs, make sure you retorque them with an inch-pound torque wrench. They are pretty touchy and like to be pressing into the block with just the right amount of pressure to work properly..

 

[canviper]

Strikers, nice. :rock:

 

[Troy's QC SRT]

Damn I always wanted strikers! So jealous

 

[rottenronnie]

Strikers, nice. :rock:

Strikers are SOLD OUT!

But fear not: Santa is bringing another 10 sets just after Christmas.

 

[canviper]

But fear not: Santa is bringing another 10 sets just after Christmas.[/QUOTE]




PERFECT!

 

[Ironhead]

custom grind 232/234 .598" lift

I can tell thats a stinker cam ain,t it ?

 

[ramv10]

Anyone know what that cone looking thing is for, inside belanger headers?

 

[ramv10]

 

[VENOMOUS1 RACING]

Yes the " pickle" as Lou calls it promotes off idle through midrange hp and torque where going to long tubes usually you'll lose that and gain up top
Leave it!!!

 

[SergioL.]

Can you post pics of the work you did to the intake manifold?