JB WELDHow do you put it back together? I would assume welding but I'd be scared to cut into it like that.
JB WELD
I should get it back tomorrow. Will post dyno results problably the following weekend. I've see this dudes work and its pretty impressive.
Better before and after pic.
JB WELD
Super glue
Plasma to open it up, carbide bits and days of grinding
Then smooth with finer paper rolls :rock:
I should get it back tomorrow. Will post dyno results problably the following weekend. I've seen this dudes work and its pretty impressive.
Better before and after pic.
How much did this cost
JMB did mine. Not sure if they cut it open or just did the area by the opening. Once I get mine on will try and get back to the dyno so I can see what the V1R UDP added along with the intake mani.
I checked with jmb first about a full port & polish and he said he only gasket matches the runners from what I understand. I could be wrong. I should see a good hp # out of this manifold. we'll see.