Search results

So I found out that not compatible due to the fact that automatic motors have a cutout that allows access to torque converter bolts. The manuals don’t have this.

That’s why I have two extra full sets of calipers front and rear ready to go so all I gotta do is take set off put rebuilt set on if it happens again. Oh and if I get the itch to put a different color combo on all sets are painted different colors! Down time is not long and my association has no...

Hey guys it’s been ages since I’ve been on here. I was trying to find info on a thread from a long time ago about the difference from an auto engine and manual and what had to be done to use an engine from a manual rc into an auto qc? Anyone know? Thanks

I had the same exact problem with my calipers locking up. It was mainly passenger side. It would be fine upon first starting to drive then as brakes were getting used and heating up the caliper would start locking up more and more every time I would use brakes and eventually I would have to stop...

Hey guys it’s been ages since I’ve been on here. I was trying to find info on a thread from a long time ago about the difference from an auto engine and manual and what had to be done to use an engine from a manual rc into an auto qc? Anyone know? Thanks

As a rule I always reach inside the rim as far as possible when washing the rims. If you wash on a regular basis and do not let brake dust build up or let pads wear down to where you get all the metal shavings from metal on metal then your rims should stay looking almost new. Also I never use...

I have this exhaust... only complaint is where the joints are, the clamps after a while start leaking. You can only tighten them so much. I’ve got them as right as can be and still have small leaks. If the system was put together with flared ends where joints are it would be a lot better.

Looking for a set of brake air ducts and what ever brackets or fasteners needed to install them. Thanks

Did they go rt in like ceramic or did you have to modify calipers? Thanks

Still have it?

What was the cost for this repair? I’ve been out of commission for a long time because of mine.

Yeah... What he said. If it definitely screeching from power steering pump pulley then u may be on your way to having to get a new pump.

Id take the money and run. Definitely be able to buy one for way less than what you sell yours for with even less mileage.

There are really good videos on YouTube on how u can fix it without taking out the dash. Also someone makes a repair kit out there that fixes the problem

From my experience, when water pump goes you usually have water leaking from around pump shaft because usually it's the bearing that fail causing it to also leak. Can you see water circulating with the radiator cap off? Also you wouldn't have been able to bleed air out if water pump was bad when...

No... The p0442 will not cause that. Common issue as I've been driving mine for a couple years now with that code as well. Its the vacuum canister on mine that causes that code. Check your throttle position sensor

Ok.. Thanks

Are you going to use the TIPM or the mounting bracket that it fastens to the wheel well with? I'd be interested in both or the mounting bracket. Thanks

So basically with shipping because of price adjustment to $2800, you are looking at around $3500. Correct?